Teejet Tilt Compensation Module Guide_SmartPad II Bedienungsanleitung PDF herunterladen

Tilt Compensation Module for SmartPad II

TILT COMPENSATION MODULE

Bulletin 98-01151 R1

Page 1 of 2

Tilt Sensor Operation

The SmartPad II must be loaded with Fieldware software, version 4.03 or higher to be compatible with

the Tilt Sensor. When operating the Tilt Sensor the position data coming from the GPS receiver will be

compensated for vehicle tilt errors and then corrected information will be sent to the console.

When the vehicle experiences a sideways tilt, any guidance information is affected: For example, if the

GPS sensor is 12 feet (3.65m) above the ground, a 10-degree tilt gives a 2-foot (0.61m) positioning

error.

Tilt Sensor Functions

There are three LEDs visible on the Tilt Sensor which indicate the following:

• Blue - Blinks two times per second when the unit is powered and

running

• Green - Steady ON when tilt correction is enabled, OFF otherwise

• Yellow - Blinks one time per second when valid GPS location data

is being received (NMEA-0183 GGA)

Tilt Sensor Mounting Recommendations

1. Mount as close to the center of the vehicle side to side as possible.

2. Mount sensor on a parallel plain to the GPS antenna so both the antenna and the

sensor tilt the same degree.

3. Mount so the sensor is level and connector is pointing upward.

4. Sensor should be rigidly mounted to minimize vibration, because vibration will degrade

the ability to sense tilt.

5. Mid-Tech recommends using nuts and bolts or self tapping screws through the two

mounting holes on each end of the sensor.

6. The arrow on sensor decal must point toward the front of the vehicle.

7. Do NOT mount near extreme temperatures, upside down, or on its side.

Figure 1: Tilt Sensor Example

1 2

Inhaltsverzeichnis

Seite 1 - Tilt Sensor Functions

Tilt Compensation Module for SmartPad II TILT COMPENSATION MODULE Bulletin 98-01151 R1Page 1 of 2Tilt Sensor Operation The SmartPad II must be loade

Seite 2 - SmartPad II Settings

Page 2 of 2SmartPad II SettingsOnce the Tilt Sensor is properly installed and connected to the SmartPad II, two initial setup steps must be performed;

Kommentare zu diesen Handbüchern

Keine Kommentare

Teejet Tilt Compensation Module Guide_SmartPad II Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Computers Teejet Tilt Compensation Module Guide_SmartPad II herunter. TeeJet Tilt Compensation Module Guide_SmartPad II User Manual [fr] [de] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computers Teejet Tilt Compensation Module Guide_SmartPad II