Teejet IC18 SPRAYER JOB COMPUTER Bedienungsanleitung PDF herunterladen (Seite 41)

98-05204 R1 US

ISOBUS Job Computer : IC18 Sprayer

OVERVIEWSETUPAPPENDIX GETTING STARTEDOPERATION

USER INTERFACE

User Interface allows the operator to select the system virtual terminal (VT), switchbox pairing, BoomPilot ECU

pairing and soft key numbering as well as view serial numbers and ECU identication number.

MAIN SETUP MODE MENU STRUCTURE

| | | | | |

Counters Job Parameters Machine User Interface Communication Help

1. From the Main Setup Screen ,

Figure 3-30: User Interface

select USER INTERFACE.

NOTE: Settings are NOT automatically saved when

selected. The ACCEPT KEY must be selected

to save the setting. Select the ESCAPE KEY

to escape without saving settings and return to the

previous menu.

Use Preferred VT

Use Preferred VT sets the virtual terminal preference to

either on or off. If “On” is selected, the preferred VT will

be used. If “Off” is selected, the system will arbitrarily

select which VT to use (if more than one VT is available

on the ISOBUS CAN).

NOTE: This should always be set to "off" unless another VT is on the CAN bus.

• To set the Use Preferred VT mode, select an option from the drop down menu or use the UP/DOWN

ARROWS to highlight the option.

This IC18

Displays IC18's serial number and associated ECU identication number.

Pair with Switchbox

The pairing of a switchbox can be set to be done automatically, not at all or to a specic switchbox ECU ID

number on the CAN network.

• To set the Switchbox pairing, select an option from the drop down menu or use the UP/DOWN ARROWS to

highlight the option.

Pair with BoomPilot ECU

The pairing of a BoomPilot ECU can be set to be done automatically, not at all or to a specic BoomPilot ECU ID

number on the CAN network.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Keine Kommentare

Teejet IC18 SPRAYER JOB COMPUTER Bedienungsanleitung Seite 41