Teejet UniPilot Bedienungsanleitung PDF herunterladen (Seite 9)

98-05226-ENUS R4

UniPilot

Six Simple Steps to Get Going!

1. Assemble Universal Mounting Bracket Kit on steering column so that it can be adjusted with the installation of the

UniPilot ESM.

• See page 8 for recommendations for your specic steering column.

2. Install UniPilot ESM and check spacing.

• Attach the UniPilot ESM to the mounting bracket. The steering wheel should rotate freely around when the UniPilot

ESM is in the Operating Position. When in the Standby Position, there should be 1.6 in. / 40 mm of space between the

UniPilot contact wheel and the vehicle's steering wheel.

3. Secure or rmly tighten the mounting parts to Steering Column.

4. Connect Electronics.

5. Program Specic Settings on Guidance Console.

6. Activate & GO!

NOTE: All references to left and right are stated as if the user is seated in the

driver’s seat.

All references to front and back are stated in relationship to the front and

back of the vehicle.

Assemble Mounting Bracket

The purpose of the mounting bracket is to securely mount the UniPilot ESM (Electric Steering Motor) to the steering column and keep the UniPilot

ESM from rotating around the steering wheel.

Depending on the shape of your steering column, a different mounting bracket conguration may be needed. The following page illustrates a few

examples of installation methods. If you do not see an example that illustrates your vehicle's requirements, please contact your dealer or TeeJet

Customer service representative for clarication on your specic vehicle's installation.

1. Assemble Universal Mounting Bracket Kit on steering column so that it can be adjusted with the installation of the UniPilot ESM.

The mounting bracket will be secured after the UniPilot ESM is assembled.

Figure 1-3: Mounting Bracket Parts

Standby Position Operating Position

1.6 in. / 40 mm of space

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Keine Kommentare

Teejet UniPilot Bedienungsanleitung Seite 9